Overview Of Main Components; Top Cover Kit; Drawer Panel Kit - Midea G01 Service Manual

4.OVERVIEW OF MAIN COMPONENTS

4.1 Top cover kit

1. Parts component
Top cover is made up of hyperbaric plate, top
cover-f and top cover-b. Both top cover-f and
top cover-b are ABS materials. Front of top
cover lock to the panel support of this machine's
cabinet, and back of top cover fastnesses to the
U-type backside of cabinet with screw.
Two-piece of hyperbaric plate is covered by
melamine which is waterproof and fireproofing,
and furthermore, the dirt and smudge on its
surface could be erasured easily.
2. Summery about function
The two screws fixing the top cover screw into the
cabinet to avoid loosening.
Chang and maintain PCB kit, pressure sensor,
filter, inlet valve after unpack top cover kit.

4.2 Drawer panel kit

1. Drawer, Drawer panel and Softener cap
Drawer panel kit is consist of drawer, drawer panel and softener cap. Drawer panel is
clipped on the face of draw without screw and softener cap in the center of drawer.
According to the need of costumers, different detergent could be placed in three boxes
of drawer respectively, and concretely the right one is pre-wash box, the left one is main
wash box and the center one is softener box. Certainly user can put decolourant, spicery
and softener in the center one to improve washing performance.
After water fill in the drum through drawer, siphon structure of inlet system ensure that
drawer have no remanent water or wash liquid.
Drawer can be taken out and cleaned up: Unfold the drawer up to 10cm, and then take
out the drawer at the same time press the elastic plate to avoid injuring the softener box.
What is noticeable: during cut the softener cap in the detergent box, you have to press
the protuberant support of its end.
During the washing machine's in work, it should remind user of closing the drawer, or
else, the detergent can't be flowed into the drum completely, and what is worse water
may flow out from the outside of the cabinet.
2. Draw panel deck
The material of drawer panel kit is PMMA.
P.20