Disassembly And Replacement - Toshiba e-STUDIO167 Service Manual

14.7 Disassembly and Replacement

[A] Automatic Duplexing Unit (ADU)
(1) Take off the right rear cover.
P.2-22 "[I] Right rear cover"
(2) Remove 1 screw and 1 ground wire.
(3) Disconnect 1 connector.
(4) Open the transfer unit and release the ADU
stopper.
(5) Take off the ADU cover while sliding it toward
the right.
(6) Remove 4 screws and take off the ADU.
Note:
When installing the ADU, be sure to put the
ADU stopper on the rear side through the
rear slit of the ADU.
e-STUDIO167/207/237
AUTOMATIC DUPLEXING UNIT (ADU) (OPTION: MD-0103)
ADU stopper
ADU
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
14 - 12
Connector
Ground wire
Fig. 14-8
Fig. 14-9
Slit ADU stopper
Fig. 14-10