Disassembly And Replacement - Toshiba e-STUDIO167 Service Manual

9.5

Disassembly and Replacement

[A] Main motor (M3)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 2 screws,
and then take off the main motor.
[B] Toner motor (M2)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 1 screw,
take off the toner motor with the bracket, and
then remove 1 bushing and 1 gear.
e-STUDIO167/207/237
DRIVE UNIT
Connector
Tonner motor
Bushing
Bracket
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
9 - 6
Main motor
Fig. 9-3
Connector
Gear
Fig. 9-4