Toshiba e-STUDIO167 Service Manual page 232

(3) Pull out the center heater lamp and side
heater lamp.
Notes:
• When installing the heater lamps, be sure
not to mix up the upper heater lamp and
the lower heater lamp.
The upper heater lamp has a coil wound
up on its center part, and the lower heater
lamp has coils wound up on its both
edges.
• When installing the heater lamps, be sure
to face up their weld sides.
• Do not touch the lamps directly with your
hands.
• The connector on each end of the har-
ness which connects to the center heater
lamp has a small screw hole. The con-
nector on each end of the harness which
connects to the side heater lamp has a
big one.
[G] Fuser roller
(1) Take off the center heater lamp and the side
heater lamp.
P.13-17 "[F] Center heater lamp / Side
heater lamp (LAMP1/LAMP2)"
(2) Take off the separation fingers.
P.13-16 "[E] Separation finger"
(3) Take out the fuser roller upward.
Notes:
• When installing the fuser roller, slide each
bushing on both edges of the roller out-
ward so that the bushings will engage
with the frame and the installation will be
secured.
• Do not apply force onto the roller because
it may be deformed.
e-STUDIO167/207/237
FUSER / EXIT UNIT
Upper side : center heater lamp
Lower side : side heater lamp
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
13 - 18
Center heater lamp
Side heater lamp
Fig. 13-23
Weld
Fig. 13-24
Fuser roller
Fig. 13-25