Description Of Abnormality - Toshiba e-STUDIO167 Service Manual

4.3.2

Description of abnormality

(A) Add paper
[In cases of the equipment drawer or the PFU / PFP drawer ] (When drawer is not installed)
• Drawer empty sensor detects the presence or absence of paper.
No drawer detected
È
"Add paper" is displayed
The LED on the control panel corresponding to the drawer blinks (When the drawer is selected)
È
[START] button disabled
[In cases of the equipment drawer or the PFU drawer] (When the drawer is installed)
Drawer detected
È
Paper empty sensor OFF
È
"Add paper" is displayed
The LED on the control panel corresponding to the drawer blinks (When the drawer is selected)
È
[START] button disabled
[In case of the PFP drawer] (When the drawer is installed)
• When the power is turned ON or the drawer is installed
PFP starts initialization
È
The detection of paper existence starts
Tray-up motor ON – Tray is raised
At this time, the tray-up sensor and paper empty sensor are OFF
Æ When the tray-up sensor is not turned ON in a fixed period of time
Tray abnormality Æ "Add paper" is displayed regardless of the existence of paper
Æ Cleared by turning the power ON and then OFF
Æ The tray-up sensor is turned ON in a fixed period of time
- The tray-up motor is stopped.
At this time, if the paper empty sensor is
e-STUDIO167/207/237
GENERAL OPERATION
ON: It is judged that there is paper
OFF: It is judged that there is no paper
The lamp on the control panel corre-
sponding to the drawer blinks (When
the drawer is selected)
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
4 - 6
È