(E) Developer unit not installed properly
•
Disconnection of the connectors of the developer unit
È
"Set process unit" is displayed.
[START] button disabled.
È
Solution: Connect the connectors of the developer unit and close the front cover.
(F) Call for service
Error code is displayed instead of the set number by pressing the [CLEAR] button and [8] button
simultaneously when the service call lamp is blinking.
Refer to the error code table in the Service Handbook.
e-STUDIO167/207/237
GENERAL OPERATION
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
4 - 10