Toshiba e-STUDIO167 Service Manual page 117

(3) Take off the CIS case.
Notes:
1. When installing the CIS case, be sure to
fit the shaft of the equipment in the shaft
guide attached on the bottom of the CIS
case.
2. When installing the CIS case, install it so
that the "L" shaped portion of the bottom
of the CIS case comes under the CIS unit
drive belt-1.
[I] CIS unit drive belt-1
(1) Take off the CIS case.
P.6-24 "[H] CIS case"
(2) Loosen 1 fixing screw of the tension bracket.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Fig. 6-33
Shaft
Fig. 6-34
Tension bracket
Fig. 6-35
6 - 25
CIS case
L shaped potion
Shaft guide
e-STUDIO167/207/237
SCANNER
6