Switching On Your Monitor; Setup Diskette For Windows 2000 - IBM T54H User Manual

The AC adapter and signal
cable are connected to
your monitor. If you wish to
change these or to fit a different
stand, see Further Help on
page 25.

Switching on your Monitor

Setup Diskette for Windows 2000

This section must be
completed before
continuing with the
Windows 2000 confguring
for your monitor on page 11.
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends using
1024 x 768 at a refresh rate of
60Hz.
1. Switch on the power source and your computer.
2. Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.
3. Turn on the monitor and then the computer.
by following the instructions in the Configuring your
4. Run
A S
UTO ETUP
Monitor section on page 6.
To use the Plug and Play feature in Windows 2000, files should be loaded
from the IBM Flat Panel Monitor Installation diskette.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows 2000.
4. Open the
D P
ISPLAY ROPERTIES
and then double clicking on the
C P
ONTROL ANEL
5. Select the
S
ETTINGS
6. Select the
A
DVANCED
7. Select the
M
ONITOR
8. Select the
P
ROPERTIFS
9. Select the Driver tab.
10. Open theUpgrade Device Driver Wizard window by clicking on UPDATE
DRIVER and then select the NEXT button.
11. select the "Display a list of the known dirvers for this device so that lcan
choose a specifc driver" and then sefect the NEXT button.
12. Inset the Setup diskette into drive A: and select the HAVE DISK button.
13. select OK.
window by clicking on
tab.
button.
tab.
button.
, ,
S S
TART ETTINGS
icon.
D
ISPLAY
7