Table of Contents
Advertisement
3. Connect the power cord to the power adapter and then plug the power cord
into a properly grounded outlet. Next, reconnect the power cord(s) to your
computer and all attached devices.
Switching on your Monitor
1. Switch on the adapter power source by pushing the power switch
rear panel of the monitor.
2. Switch on your monitor by pushing and releasing the power switch marked [ ]
at the front of the bezel.
[To switch off your monitor, push and release the power switch again.]
3. Switch on your computer.
4. If you are using the analog connector, run AUTO SETUP by following the
instructions in the Auto Setup section on page 9.
on the top
A
5
Hide quick links:
Advertisement
Table of Contents
