Switching On Your Monitor - IBM 6736-HB0 User Manual

3. Connect the power cord to the monitor and then plug the power cord into a

Switching on your Monitor

1. Switch on your computer.
2. Switch on the monitor power source by pushing the power switch
3. Switch on your monitor by pushing and releasing the power switch marked [
4. To update or install device drivers, follow the instructions in the Device Driver
5. If you are using the analog connector, run Image Setup by following the
8
properly grounded outlet. Next, reconnect the power cord(s) to your computer
and all attached devices.
rear panel of the monitor.(See Figure B)
at the front of the bezel.
[To switch off your monitor, push and release the power switch again.]
Installation section on page 9.
instructions in the Automatic Image Setup section on page 12.
on side
A
]