Switching On Your Monitor - IBM T750 User Manual

Hide thumbs Also See for T750:
Table of Contents

Advertisement

Switching on your Monitor

8
7.
Connect the DVI connector at the other end of the signal cable to the
DVI port located on the back of the graphics adapter. See picture below.
8.
Replace the rear covers.
9.
Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
10. Switch on the power source and your computer. To turn on the monitor,
push and release the power switch
the power switch again.
1.
Switch on the power source and your computer.
2.
Switch on your monitor by pushing and releasing the power switch
marked
.
To switch off your monitor, push and release the power switch again.
3.
Turn on the monitor and then the computer.
4.
Run
A
S
UTO
ETUP
Installation section on page 9.
Signal Cable
by following the instructions in the Device Driver
graphics adapter
DVI
. To switch it off, push and release

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents