Display Modes; Further Information - IBM T54H User Manual

Display modes

For image problems, you
may want to run AUTO
Setup again before consulting
to this section. In most cases,
AUTO SETUP can fix the
problems. See Auto Setup on
page 10 and 11 for details.
The display mode the monitor uses is controlled by the computer. Therefore,
you should refer to your computer documentation for details on how to
change display modes.
The image size, position and shape may change when the display mode
changes. This is normal and the image can be readjusted using
and the monitor controls.
Unlike CRT monitors, which require a high refresh rate to minimize flicker,
TFT technology is inherently flicker-free. If possible, configure your computer
for 1024 × 768 addressability at 60Hz vertical refresh rate.
For the display modes listed below, the screen image has been optimized
during manufacture.
Factory Set Display Modes
Addressability
640 × 480
640 × 480
640 × 480
720 × 400
800 × 600
800 × 600
800 × 600
800 × 600
832 × 624
1024 × 768†
1024 × 768
1024 × 768
640 × 480
† Recommended
'Note: VESA timings are as detailed in the VESA "Display Monitor Timing Specification". Version 1.0,
Revision 0.8, dated 09/17/98.'

Further Information

Refresh Rate Horizontal Frequency
60 Hz
72 Hz
75 Hz
70 Hz
75 Hz
72 Hz
60 Hz
56 Hz
75 Hz
60 Hz
70 Hz
75 Hz
67 Hz
A S
UTO ETUP
31.5 kHz
37.9 kHz
37.5 kHz
31.5 kHz
46.9 kHz
48.1 kHz
37.9 kHz
35.2 kHz
49.7 kHz
48.4 kHz
56.5 kHz
60.0 kHz
35.0 kHz
21