Connecting Your Monitor; Switching On Your Monitor - IBM T56A Manual

Connecting your Monitor

Be sure to read the 'Safety
Information' at the front of this
User Guide before carrying out
this procedure.
i
The AC adapter and signal
cable are connected to
your monitor. If you wish to
change these or to fit a
different stand, see Further
Help on page 22.

Switching on your Monitor

4
1. Turn off your PC and all attached devices.
2. Connect one end of the monitor signal cable to the rear panel of the
computer and tighten the screws. Be sure the signal cable aligns with
the 15-pin connector.
3. Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
1. Switch on the power source to your monitor.
2. Switch on your monitor by pushing and releasing the power switch
marked [ ].
[To switch off your monitor, push and release the power switch again.]
3. Switch on your computer.
4. Run AUTO SETUP by following the instructions in the Auto Setup
section on page 8.