Connecting Your Monitor; Switching On Your Monitor - IBM T545H User Manual

Connecting your Monitor

Be sure to read the 'Safety
Information' at the front of this
User Guide before carrying out
this procedure.
i
If you system is equipped
with a digital Video card
using a DVI connector, change
the signal cable to the DVI-D
cable provided (See page 22
for details)
i
The AC adapter and signal
cable are connected to
your monitor. If you wish to
change these or to fit a
different stand, see Further
Help on page 22.

Switching on your Monitor

4
1. Turn off your computer and all attached devices.
2. Connect the monitor signal cable to the Video output of your computer
and tighten the thumscrews. Ensure that the connectors align. Do not
force the connectors as this may bend the pins.
3. Connect the power cord. Connect it to the power adapter first insert the
plug into a properly grounded outlet.
1. Switch on the power source to your monitor.
2. Switch on your monitor by pushing and releasing the power switch
marked [ ].
[To switch off your monitor, push and release the power switch again.]
3. Switch on your computer.
4. Run AUTO SETUP by following the instructions in the Auto Setup
section on page 8.