Section 10: Digital Trims; Section 11: Low Battery Alarm; Section 12: Trainer - Hangar 9 Alpha 40 Assembly Manual

Section 10: Digital Trims

The DX5e features digital trims. Each time a trimmer is moved the servo output will change one step. If the
trimmer is held, the output will scroll in that direction until the trimmer is released or the output reaches its end.

Section 11: Low Battery Alarm

When the battery voltage drops below 4.7 volts an alarm will sound and the voltage LEDs will flash.

Section 12: Trainer

The DX5e offers a Trainer function that allows the transmitter to operate as a master or slave. The trainer switch is located
on the back left of the transmitter. When using the trainer function, plug the trainer cord (SPM6805) into the trainer port in
both the master (controlling) and the slave (training) transmitters. The master transmitter must have the power turned on
and the slave transmitter must have the power turned off.
Note: The DX5e trainer system is compatible with all JR
MASTER
The DX5e transmitter can be used as a master but the slave transmitter must have the same programming (i.e. reverse
switch positions) as the master.
SLAvE
When using the DX5e transmitter as a slave with another DX5e, it's necessary to match all the reverse switch positions.
22
12843.1_HAN_Alpha40_SpektrumManual.indd 22
Throttle Trim
Rudder Trim
Mode 2
Elevator Trim
Aileron Trim
® and Spektrum transmitters.
6/4/10 10:18:21 AM