Table of Contents
Advertisement
Section 6: Centering the Control Surfaces
Required Parts
• Assembled airframe
Required Tools and Adhesives
• Ruler
Checking the elevator
Center the elevator stick and trim. If necessary, detach the
clevis from the control horn and thread the clevis in or out
on the elevator pushrod until the elevator is aligned with
the stabilizer as shown. Remember to attach the clevis
back in the center hole as described earlier in the manual.
12843.1_HAN_Alpha40_SpektrumManual.indd 19
Checking the Rudder
Center the rudder stick and trim. If necessary, detach the
clevis from the control horn and thread the clevis in or out
on the rudder pushrod until the rudder is aligned with the
fin as shown. Remember to attach the clevis back in the
center hole as described earlier in the manual.
Checking the Ailerons
Center the aileron stick and trim. If necessary, detach the
clevis from the control horn and thread the clevis in or out
on each aileron pushrod until the ailerons are aligned with
the wing as shown. Don't forget to align both ailerons at
this time. Remember to attach the clevis back as described
earlier in the manual.
19
6/4/10 10:18:16 AM
Advertisement
Table of Contents
