Configuring Smc9432Tx Lan Card; Configuring Intel Pro/100+ Lan Card - NEC SERVER HX4500 Configuration Manual

Configuring SMC9432TX LAN Card

1. You should now be in a menu labeled "Choose the Server Drivers - Network
Driver."
2. Press the INSERT key to install an unlisted driver.
3. Press the F3 key. Type: A:\9432.
Press ENTER
4. Highlight "SMC9432.LAN" and press ENTER.
5. Highlight "No" and press ENTER to save existing files.
6. Highlight "Select/Modify driver parameters" and press ENTER.
7. For "Slot" parameter, enter the logical slot number where the card is
inserted. Press ENTER
8. Using the arrow keys, highlight "Autodetect" and press ENTER.
9. If you are configuring the SMC9432TX LAN card connected to a 10Mbps
line instead of the default 100Mbps line, using the arrow keys, highlight the
"Line Speed" parameter and press ENTER.
10. Enter 10 and press ENTER.
Note:
all subsequent loads of the driver default to 10Mbps line
speed. If another SMC9432TX LAN card is installed at
100Mbps line speed, the load command for it must include
"line_speed=100."
11. Using the arrow keys, highlight "Save parameters and continue." Press
ENTER.
12. At the "Do you want to select an additional network driver?" prompt, select
"Yes" if you have another LAN card or channel to configure. Press ENTER.
Repeat Step 19 in the Installing the Novell NetWare v4.11 Network
Operating System section in this chapter. If you do not have another LAN
card to configure, select "No" and press ENTER.
13. Select "Continue Installation" and press ENTER.
14. Go to step 38 in section "Installing the Novell NetWare v4.11 Network
Operating System" in this chapter.

Configuring Intel PRO/100+ LAN Card

1. You should now be in a menu labeled "Choose the Server Drivers - Network
Driver."
2. Press the INSERT key to install an unlisted driver.
3-12 Installing and Configuring Novell NetWare v4.11
After the driver is loaded with "Line_speed=10,"