Configuring 3Com 3C905Tx Lan Card - NEC SERVER HX4500 Configuration Manual

3. Press the F3 key. Type: A:\PRO_100.
Press ENTER
4. Highlight "E100B.LAN" and press ENTER.
5. Highlight "Select/Modify driver parameters" and press ENTER.
6. For "Slot" parameter, enter the logical slot number where the card is
inserted. Press ENTER.
7. Using the arrow keys, highlight "Autodetect" and press ENTER.
8. If you are configuring the Intel PRO/100+ LAN card connected to a 10Mbps
line instead of the default 100Mbps line, using the arrow keys, highlight the
"Line Speed" parameter and press ENTER.
Enter 10 and press ENTER.
Note: After the driver is loaded with "Line_speed=10," all subsequent loads
of the driver default to 10Mbps line speed. If another Intel PRO/100+ LAN
card is installed at 100Mbps line speed, the load command for it must
include "line_speed=100."
9. Using the arrow keys, highlight "Save parameters and continue." Press
ENTER.
10. 10.
select "Yes" if you have another LAN card or channel to configure. Press
ENTER.
Repeat Step 19 in the Installing the Novell NetWare v4.11 Network
Operating System section in this chapter. If you do not have another LAN
card to configure, select "No" and press ENTER.
11. Select "Continue Installation" and press ENTER.
12. Go to step 38 in section "Installing the Novell NetWare v4.11 Network
Operating System" in this chapter.

Configuring 3COM 3C905TX LAN Card

1. You should now be in a menu labeled "Choose the Server Drivers - Network
Driver."
2. Press the INSERT key to install an unlisted driver.
3. Press the F3 key. Type: A:\3C905.
Press ENTER
4. Highlight "3C90X.LAN" and press ENTER.
5. Highlight "No" and press ENTER to save existing files.
6. Highlight "Select/Modify driver parameters" and press ENTER.
At the "Do you want to select an additional network driver?" prompt,
Installing and Configuring Novell NetWare v4.11 3-13