Christie LX750 User Manual page 49

3.7.2 Communication setup
1) Using the SERIAL OUT SETTING menu, select the proper baud rate and
parity for the CONTROL OUT port, according to the specification of the RS-
232C port of the connected device. (
- SERVICE – COMMUNICATION – SERIAL IN SETTING/SERIAL OUT
SETTING)
BAUD RATE
Data length
2) Using the COMMUNICATION TYPE menu, select the NETWORK BRIDGE
for the CONTROL OUT port. (
SERVICE – COMMUNICATION – COMMUNICATION TYPE)
3) Using the COMMNICATION METHOD menu set up the proper method for the
CONTROL OUT port, according to your use. (
menu - SERVICE – COMMUNICATION – COMMUNICATION METHOD)
NOTE • The OFF is selected for the COMMUNICATION TYPE as the default
setting.
• Using the COMMUNICATION menu, set up the communication. Remember
that an unsuitable setup could cause malfunction of communication.
3.7.3 Communication port
For the NETWORK BRIDGE function, send the data from the computer to the
projector with using the Network Bridge Port that is configured in the "Port
Settings" of web browser. (
NOTE • Any number between 1024 and 65535 can be set up as the Network
Bridge port number. It is set to 9717 as the default setting.
LX750/LW650/LS+700 User Manual
020-000160-01 Rev. 1 (04-2009)
Item
4800bps/9600bps/19200bps/38400bps
PARITY NONE/ODD/EVEN
8 bit (fixed)
Start bit 1 bit (fixed)
Stop bit 1 bit (fixed)
3.1.4 Port settings – Network Bridge Port)
3. Management with Web browser software
Operating Guide - OPTION menu
Condition
Operating Guide - OPTION menu -
Operating Guide - OPTION
47
Network Guide