Options - Sony BVM-D9H1j Operation Manual

Other features
• The monitor's various functions and operating
conditions can be set with on-screen menus.
• Has both RS-485 serial remote and relay contact
parallel remote control connectors.
• H delay and V delay functions for simultaneous
checking of the horizontal and vertical
synchronization signals. VITS (Vertical Interval Test
Signal) checking is also possible.
• Auto and manual degaussing.
• The monitor may be mounted in an EIA-standard 19-
inch rack, using an optional MB-520 (for 9-inch
monitor) or BKM-30E14/31E14 (for 14-inch
monitor) Rack Mount Kit.
• The appearance of the monitor can be changed to
16:9 or 4:3 display by the replacement of a mask.
• Operable by using a Sony lithium ion battery (BP-
L60/L90A) or DC 12 V external power source.
(BVM-D9H1U/D9H1E/D9H1A/D9H5U/D9H5E/
D9H5A only)
• Built-in audio reproduce circuit and speaker. (BVM-
D9H5U/D9H5E/D9H5A only)

Options

For external control
BKM-10R Monitor Control Unit
A controller for the BVM-D9H1/D14H1 series video
monitors, allowing you to control multiple monitors
from one control unit.
BKM-11R Monitor Control Unit
A controller for the BVM-D9H/D14H and other BVM/
HDM series video monitors, allowing you to control
multiple monitors from one control unit.
BKM-14L Auto Setup Probe
A probe, allowing the automatic adjustment of this
monitor's color temperature.
For installation
MB-520 Mounting Bracket
Mounting bracket to mount one or two BVM-D9H1U/
D9H1E/D9H1A/D9H5U/D9H5E/D9H5A in a 19-inch
EIA standard rack.
MB-519 Mounting Panel
Panel for the BVM-D9H1U/D9H1E/D9H1A to fill up
the space created when mounting a video monitor to a
rack with the MB-520 mounting bracket.
MB-509 Mounting Panel
Panel for the BVM-D9H5U/D9H5E/D9H5A to fill up
the space created when mounting a video monitor to a
rack with the MB-520 mounting bracket.
BKM-30E14 Rack Mount Kit
Rack mount kit for mounting the BVM-D14H5U/
D14H5E/D14H5A in an EIA standard 19-inch rack.
BKM-31E14 Rack Mount Kit
Rack mount kit for mounting the BVM-D14H1U/
D14H1E/D14H1A in an EIA standard 19-inch rack.
Others
VF-508 Monitor ENG Kit
Kit for the BVM-D9H1/D9H5 that includes a light
intercepting hood which is mounted on the front of a
monitor, and a connector protector which is mounted
on the rear.
Input adaptors
The input connector panel is configured by sliding the
optional input adaptor into the input option slot at the
rear of the monitor. Up to three adaptors can be
installed to the monitor.
The input signal type for each connector of the adaptor
is set with the INPUT CONFIG menu, in accordance
with the configuration of the connector panel.
Note
When installing the adaptor, be sure to perform the
necessary input signal setup with the INPUT CONFIG
menu. If the setup is not performed, the adaptors may
not function correctly.
For information about the INPUT CONFIG menu, see "[C]
Setting the Input Configuration — INPUT CONFIG Menu"
on page 35(E).
5
(E)