Sony BVM-D9H1j Operation Manual page 85

Function buttons in SHIFT OFF mode (LEDs of function buttons in green)
16 : 9
SYNC
BLUE
ONLY
R
MONO
G
APT
B
COMB
F1
F3
F2 F4
ADDRESS MARKER
(Underscan) button: When this button is pushed in (ON), the picture is
underscanned by 3%, and four ends of the raster is displayed on the screen.
(H delay) button: When this button is pushed in (ON), the picture moves
horizontally, and a horizontal sync signal appears approximately one quarter in the
left edge of the screen.
• The brightness of the picture increases automatically, and it makes it easy to check
the sync part.
• If it is pressed together with the
(V delay) button: When this button is pushed in (ON), the picture moves vertically,
and a vertical sync signal appears approximately in the center of the screen.
• The brightness of the picture increases automatically, and it makes it easy to check
the sync part.
• If it is pressed together with
MONO button: When this button is pushed in (ON), a monochrome picture is displayed.
When the buttons is off, the monitor switches automatically color mode.
Notes
• The MONO button does not function with the RGB signal input.
• When the NTSC or PAL color signals are received and color burst signals are not
input, the monitor does not switch to color mode.
APT (aperture) button: When this button is pushed in (ON), the frequency response
can be modified. The degree of modification is set with the menu. (When RGB
signals are input, the button does not function.)
COMB button: This button does not function with this monitor.
However, when the BKM-127W NTSC/PAL Input Adaptor (optional) is installed and the
NTSC or PAL color signals are received, the monitor can be used with the comb filter
turned on.
F1 button: When this button is pushed in (ON), the characters disappear from the
monitor on the MANUAL menu of the level 1 of the CONTROL PRESET ADJ menu, the
MANUAL menu of the level 1 of the COLOR TEMP ADJ menu, and the ALIGNMENT
menu.
F2 button: When this button is pushed in (ON), you can access directly the MANUAL
menu of the level 1 of the COLOR TEMP ADJ menu, if the short-cut function is assigned
to this button.
ADDRESS button: When this button is pushed in (ON), the ADDRESS menu appears
on the screen. By using the ADDRESS menu, operation conditions for multiple
monitors are set.
For more information about the ADDRESS menu, see "Selecting the Monitor to
Control — ADDRESS Menu" on page 45(E).
button, a pulse cross picture is displayed.
button, a pulse cross picture is displayed.
19
(E)