Sony BVM-D9H1j Operation Manual page 84

Location and Function of Parts
6 Menu operation buttons
MENU button: Press to display the monitor
UP MENU menus.
UP/DOWN buttons: Press to select the
DOWN ENTER
items and setting values.
ENTER button: Press to confirm the items
and values entered (Ent button on the
numeric keypad 4 has the same function).
For more information about menu operation, see "Basic
Menu Operations" on page 25(E).
7 POWER lamp
Lights when the monitor is put into operation mode
from standby mode (see STANDBY lamp 8) by
pressing the POWER switch 2.
Note
When the STANDBY lamp 8 is blinking, the monitor
cannot be put into operation mode (internal data
initialization is taking place). Wait until the
STANDBY lamp 8 is steadily lit.
8 STANDBY lamp
Lights when the monitor is in standby mode. The
monitor will be in standby mode under the following
conditions:
• The MAIN POWER switch (on the rear panel) is
turned on when the STANDBY MODE menu of the
SYSTEM CONFIG menu is set to ON (the
STANDBY lamp will blink for a few moments after
the switch is turned on, then will light).
• The monitor is changed from operation mode to
standby mode by external control.
For information about the SYSTEM CONFIG menu, see
"[E] Setting the Power-Up Conditions and Data about the
Screen Display — SYSTEM CONFIG Menu" on page
39(E).
9 OVER LOAD lamp
Lights when some malfunction has occured.
When the OVER LOAD lamp is lit, consult your
nearest Sony service facilities.
18
(E)
0 SHIFT button
Press to select one of the two functions designated to
the function buttons !¡.
Each time the SHIFT button is pressed, the LED turns
on (SHIFT ON: lits in amber) and off (SHIFT OFF.)
SHIFT OFF: The functions indicated above the
function buttons can be used (the LED of the
function button lits in green.)
SHIFT ON: The functions indicated below the
function buttons can be used (the LED of the
function button lits in amber.)
!¡ Function buttons
Change the operation conditions for the monitor.
Each time the button is pressed, the LED turns on and
turns off, and the operation conditions are changed.
Each button has two functions. Select one of the two
functions by pressing the SHIFT button 0. When the
SHIFT button is set to ON, the LED lights in amber,
and when the SHIFT button is set to OFF, the LED of
each button lights in green.
For the functions of the function buttons in case of SHIFT
OFF and SHIFT ON, see pages 19(E) and 20(E).
!™ OPTION connector
Used to connect the BKM-11R Monitor Control Unit
or Auto Setup Probe (BKM-14L, etc.)