Test Run From Outdoor Main Pcb - Fujitsu Airstage J-II Service Manual

1-2-6 Test Run From Outdoor Main PCB

All the indoor units connected to the outdoor unit can be test-operated by push button setting.
SWITCH POSITION
Outdoor unit printed circuit board
TEST RUN SETTING
For a detailed description of push button operation, refer to the [D&T manual Chapter 6. SYSTEM DESIGN]
< Monitoring condition >
LED105 LED104
MODE / EXIT
< Mode select condition >
[ Monitoring mode ]
LED105 LED104
ENTER
< Fuction select condition >
[ Cooling test run ]
LED105 LED104
ENTER
< Pursuance completion >
LED105 LED104
ENTER
< Return to mode select condition >
LED105 LED104
[ Setting mode ]
LED105 LED104
SELECT
SELECT
Press the ENTER button for at least 3 seconds.
Press the "ENTER" button or Time out ( 5 seconds)
MODE / EXIT
POWER
MODE
LED101
(GREEN)
LED105
MODE
SELECT
/EXIT
SW107 SW108
Note
There are the following 2 methods of resetting test operation.
(1) Automatic reset when 60 minutes has elapsed.
(2) Reset when operation stop was performed.
[ Function mode ]
SELECT
[ Test run stop ]
LED105
SELECT
< Return to monitoring condition >
LED105 LED104
01-09
ERROR
7 Segment
LED102
LED Lamp
(RED)
LED104
ENTER
Push button switch
SW109
SELECT
LED105 LED104
LED104
SELECT
example, Normal indicate : [ Cooling mode ]
[ Error history mode ]
LED105 LED104
[ Central control setting
Forced reset ]
LED105 LED104