Optional Cleanup - WAGNER POWER MAXROLLER Owner's Manual

Latex materials:
Follow these steps ONLy if you used latex materials and do not have a garden hose available.
1. Elevate roller arm and hang from an empty bucket.
The unit must be lower than the arm in order for air
to be completely purged from the paint hose (do not
submerge roller handle).
*
3. While unit is self-cleaning, thoroughly clean the roller
cover, core and cap.
5. Press quick-release tabs and remove the roller arm from
the roller handle. Remove any remaining paint with the
appropriate cleaning solution and a damp cloth (DO
NOT SUBMERgE HANDLE!).
Switch the unit OFF (O) prior to removing any accessories
or components, and make sure your floors and furnishings
are protected from dripping paint.
English

Optional Cleanup

The empty bucket should be
larger than the cleaning bucket.
2. Turn variable speed dial to 9. FULLy PRESS AND
RELEASE the handle button, and run a minimum of
one gallon of soapy, lukewarm water through the unit
(cleaning time may vary depending upon type of paint
used).
4. Remove suction tube from solution, raise unit above
handle, and run motor until all cleaning solution is
purged from the unit. Turn variable speed dial to 0
(OFF). Unplug power cord.
A light paint film residue may remain in the paint hose
after cleaning. This is normal and will not affect the future
performance of your unit.
10
9