Cleanup - WAGNER POWER MAXROLLER Owner's Manual

Using the Quick-clean™ Feature:
• Follow these steps ONLy if you used latex-based material AND you have an available garden hose. Otherwise,
follow the Optional Cleanup - latex-materials or Optional Cleanup - oil-based materials instructions.
• Make sure you have completed steps 1-5 in Purging the Paint Hose before using the Quick-clean™ feature.
1. Unplug the power cord. Remove the paint container
from the unit, and place the unit on its side with the
Quick-clean™ adapter facing up.
The unit should be placed on its side so material will not
leak from the Quick-clean™ adapter when the plug is
removed.
3. Hang the roller arm from an empty five-gallon bucket.
While holding the suction tube over the five-gallon
bucket, slowly turn the garden hose ON. Let the water
run through the suction tube and out the roller arm holes
until the hose runs clear. Empty bucket as necessary.
5. Plug in the power cord. Make sure the paint flow
direction switch is set to "PAINT" position. Turn
the variable speed dial to 9. FULLy PRESS AND
RELEASE the handle button, and let unit run until all
fluids have been purged from the paint hose. Turn the
unit OFF, and unplug the power cord. Properly dispose
of the cleaning solution.
Cleanup (continued)
9
9
2. Remove the Quick-clean™ inlet plug from the Quick-
clean™ adapter. Insert a garden hose into the Quick-
clean™ adapter. Turn the Quick-clean™ adapter fitting
counterclockwise to secure the hose. Make sure the
washer stays inside the fitting (a). Place the unit upright.
4. Turn the garden hose off. Remove suction tube from
five-gallon bucket and replace the Quick-clean™ inlet
plug. Leave the arm hanging from the bucket.
6. Thoroughly clean the roller cover, core and cap. Press
the quick-release tabs and remove the roller arm
from the handle. Wipe any remaining paint with the
appropriate cleaning solution and a damp cloth (do
NOT SUBMERGE ROLLER HANDLE!).
(a)
English