Remove Baffl es/Wire Harness/Stator Components
C
A
Valley Baffl e
E
Cylinder #2 Baffl e
I
Crankcase Baffl e #2
Remove Valley Baffl e
Remove two lower screws on PTO side and remove
screw in valley area that includes O2 sensor mounting
bracket. Remove valley baffl e.
Remove Cylinder Baffl es
Remove screws and cylinder baffl es.
Remove Crankcase Baffl es
Remove screws and crankcase baffl es.
19 690 01 Rev. --
G
A
B
B
Mounting Bracket
F
Stator
Oil Sentry
J
™
Switch
Disassembly/Inspection and Service
H
J
C
O2 Sensor
G
Cylinder #1 Baffl e
Pressure
Oil Temperature
K
Remove Stator
Remove screws and stator. Wire harness may stay
connected to stator.
Remove Ground Wire and Wire Harness
1. Remove wire harness ground on #1 crankcase
baffl e.
2. Disconnect oil temperature sensor connector and Oil
Sentry
™
Remove Oil Sentry
only if replacing.
Remove oil temperature sensor from oil pan only if
replacing.
3. Remove wire harness from engine with stator
attached.
KohlerEngines.com
F
I
K
E
D
D
H
Crankcase Baffl e #1
Sensor
pressure switch lead.
pressure switch from oil pan
™
Wire Harness
75