Remove Stator; Remove Electric Starter; Remove Cylinder Head Baffle; Remove Valve Cover - Kohler KS530 Service Manual

Remove Stator

A Stator Wire Clip
C Screw
1. Remove screw securing stator wire clip; remove clip.
2. Remove screws securing stator to closure plate
bosses.

Remove Electric Starter

A
B
A Nut
NOTE: Before removing, observe placement of starter
in closure plate for reassembly.
Remove nuts securing starter to closure plate. Remove
starter.
22 690 01 Rev. --
C
B
D
A
B Screw
D Stator
B Starter
KohlerEngines.com
Disassembly/Inspection and Service
Remove Cylinder Head Baffl e
A
B
A Screw
Remove screws attaching cylinder head baffl e to cylinder
head and remove cylinder head baffl e.

Remove Valve Cover

A
B
A Valve Cover
NOTE: Valve cover is sealed to cylinder head using
RTV silicone sealant. When removing valve
cover, use care not to damage sealing surfaces
of cover and cylinder head. To break RTV seal,
hold a block of wood against 1 fl at face of valve
cover. Strike wood fi rmly with a mallet. If seal
doesn't break loose after 1 or 2 attempts, repeat
procedure on other side.
1. Remove screws securing valve cover.
2. Remove valve cover from cylinder head.
3. Using a brass wire brush and gasket remover or
similar solvent, clean old RTV from surface of
cylinder head and valve cover.
A
A
Cylinder Head
B
Baffl e
B Screw
65