Efi Diagnostic Flow Diagram; Start Of Test - Kohler Command Pro ECV850 Service Manual

EFI SYSTEM

EFI Diagnostic Flow Diagram

START OF TEST

KEY ON
MALFUNCTION
INDICATOR LIGHT
ON
ARE FAULT CODES
PRESENT?
NO
DOES ENGINE START?
NO
CRANK ENGINE.
DOES MIL GO OFF?
YES
KEY OFF AND KEY ON .
1
LISTEN FOR FUEL PUMP.
DOES FUEL PUMP RUN 2 ?
YES
WHILE CRANKING, CHECK
IGNITION SYSTEM
SPARK?
YES
WHILE CRANKING, CHECK
INJECTOR FUEL DELIVERY.
WET SPARK PLUG?
YES
INSTALL IN-LINE PRESSURE
GAUGE AND KEY ON.
FUEL PRESSURE
IN SPECIFICATION?
1. After turning key to OFF, wait 30 seconds before turning to ON to allow ECU to initiate another prime cycle.
2. Fuel pump module can be heard or a vibration can be felt to establish pump cycle. Fuel pump module will run for one 4-6 second prime cycle
after key switch remains off for a minimum of 30 seconds.
48
NO
YES
YES MIL GOES OFF?
YES
NO
NO
NO
NO
NO
YES
KohlerEngines.com
PROCEED TO START OF TEST FOR RETEST
REFER TO DIAGNOSTIC AID #1
SYSTEM POWER
REFER TO
DIAGNOSTIC FAULT CODE SUMMARY
CLEAR CODES
REFER TO DIAGNOSTIC AID #3
NO
RUN/ON
OPERATE AT VARIOUS SPEED/
LOAD CONDITIONS
ARE FAULT CODES
PRESENT?
NO
END OF TEST
REFER TO DIAGNOSTIC AID #4
CRANKSHAFT POSITION SENSOR
REFER TO DIAGNOSTIC AID #5
FUEL PUMP
REFER TO DIAGNOSTIC AID #6
IGNITION SYSTEM
REFER TO DIAGNOSTIC AID #7
FUEL SYSTEM ELECTRICAL
REFER TO DIAGNOSTIC AID #8
FUEL SYSTEM
REFER TO DIAGNOSTIC AID #9
BASIC ENGINE
REFER TO DIAGNOSTIC
YES
FAULT CODE SUMMARY
CLEAR CODES
19 690 01 Rev. --