Install Valve Covers; Install Breather Assembly - Kohler Command Pro ECV850 Service Manual

Install Valve Covers

Torque Sequence
1
5
4
1. Make sure sealing surfaces are clean and free of
any nicks or burrs.
2. Install valve covers on same side as they were
originally installed using new gaskets.
A J-Clip is mounted on screw closest to intake port.
3. Check position of each cover and gasket, then
torque screws to 10.9 N·m (96 in. lb.) using
sequence shown.
Breather Assembly Components
C
A Breather Cover
C Sealant Bead
E Reed Retainer
19 690 01 Rev. --
3
2
A
B
D
E
F
B Gasket
D Filter
F Reed
KohlerEngines.com

Install Breather Assembly

Torque Sequence
4
1. Make sure sealing surfaces of crankcase and
breather cover are clean and free of any nicks or
burrs. Do not scrape surfaces, as this could result
in leakage.
2. Install reed and reed retainer. Torque screw to 11.3
N·m (100 in. lb.).
3. Install fi lter. Make sure fi lter does not extend above
top surface.
4. Install breather gasket with sealant bead up
(towards cover).
5. Install cover and screws. Torque to 11.3 N·m
(100 in. lb.) following sequence.
Reassembly
5
1
3
2
93