KitchenAid KCIP 1010/I Instructions For Use Manual page 16

Hide thumbs Also See for KCIP 1010/I:
Table of Contents

Advertisement

Maintenance
Carbon filter (Recirculation mode only) Fig. 17
The filter absorbs the unpleasant smells produced
when cooking. The carbon filter can be washed
every two months in hot water with suitable
cleaning fluids, or in the dishwasher at 65°C (when
washing in the dishwasher, do a full wash without
any plates inside).
Shake off any excess water without damaging the
filter, then place it in the oven for 10 minutes at
100°C to dry it off completely.
Replace the sponge every 3 years and each time the
cloth gets damaged.
Replacing the bulbs Fig. 18
Disconnect the appliance from the mains supply.
Warning! Before touching the light bulbs make
sure they have cooled down.
1. Remove the protective cover using a small flat
screwdriver or a similar tool.
2. Replace the blown bulb.
Only use 20W max (G4) halogen bulbs, and do
not touch them with your bare hands as the oils
on your skin will cause the bulbs to blow when
switched on.
3. Fit the light cover on again (clicks into place).
If the light does not work, check that the bulb has
been inserted properly before calling the Customer
Care Centre.
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kcip 1210/i

Table of Contents