KitchenAid KCIP 1010/I Instructions For Use Manual page 10

Installation
Fig. 7
• Hook the frame to the 2 screws on the ceiling
and fit securely with another 2 screws (front
and back). TIGHTEN ALL THE SCREWS
WELL.
Fig. 8
• Chimney size: the flue comes in a standard
length and can be cut to size.
Note: The height of the flue should be the
same as the frame extension (see the
mathematical formula in Fig. 3)
• Insert the flue in the frame, check that the
welded side is turned to the back (the opposite
side from where the hood control panel will be
when installation is complete). Fit with 2
screws.
Fig. 9
• Hook the motor unit onto the frame on 4
screws previously screwed onto the unit.
Warning! Pass the electrical cable through the
motor unit so that it does not get damaged and
so that it is possible to connect to the electrical
connection box.
Note: the side with the electrical connection
box corresponds with the side (FRONT) where
the control panel will be once the hood has
been installed.
• Securely attach with 2 screws and tighten all 6
screws.
• Connect the power cable to the connection box
and close the box again.
• Connect the extraction vent pipe to the union
ring on the unit.
10