4036-310, -311
Flatbed cover removal
Note: To prevent damage, lock the flatbed scanner module while performing this repair.
1.
Remove the complete flatbed document cover. See
page
4-27.
2.
Remove the operator panel assembly. See
3.
Remove the ADF front and rear entry guides. See
page
4-47.
4.
Lock the flatbed scanner in the home position, and then place the scanner on its rear.
5.
Remove the three screws (A) from the right rear side of the scanner.
6.
Place the scanner right-side up, and open the ADF.
7.
Remove the screw (B) from the top left corner of the flatbed cover.
4-48
Service Manual
"Complete flatbed document cover removal" on
"Operator panel assembly removal" on page
"ADF front and rear entry guides removal" on
Previous
4-17.
Next
Go Back