Input Tray Tests; Printer Setup; Defaults - Lexmark 6500e Service Manual

Input Tray Tests

This test determines if the printer can feed media from any of the paper input sources. Each of the installed
sources is available within the Input Tray Tests menu.
To run the Input Tray Test:
1.
From the Diagnostics menu, touch INPUT TRAY TESTS.
2.
Select the input source.
3.
Select either Single or Continuous.
Note: If Single is selected, no buttons are active while the input device is feeding. If Continuous is
selected, Stop (
4.
At the end of the test, the printer returns to the INPUT TRAY TESTS menu.

PRINTER SETUP

Defaults

This setting is used by the printer to determine whether US or non-US factory defaults should be selected. The
following printer settings have different US and non-US values:
Printer default values
Paper Sizes setting in the General Settings menu
Default Paper Size (paper feeding sources which do not have
hardware size sensing capabilities)
Default Envelope Size
(envelope feeding sources which do not have hardware size
sensing capability)
Fax media size
PCL Symbol Set
PPDS Code Page
Universal Units of Measure
Modification of the printer setting Defaults causes the NVRAM space to be restored to the printer's factory
settings.
X
) can be pressed to cancel the test.
US value Non-US value
U.S. Metric
Letter A4
10 Envelope DL Envelope
Letter A4
PC-8 PC-850
437 850
Inches Millimeters
Diagnostic aids
4036-310, -311
Previous
Next
Go Back
3-21