Event Log; Display Log; Print Log; Clear Log - Lexmark 6500e Service Manual

EVENT LOG

Display Log

Display Log shows the message that appeared on the operator panel for each event in the log, starting with the
most recent. Use the touch-screen arrows to scroll through the log entries. To see more in-depth information
about each event, print the event log using the Print Log menu item.
Touch Back to return to the EVENT LOG menu.

Print Log

The Print Log menu item prints a detailed report of each event in the log. The first page of the event log contains
a Printer Information section similar to what is printed on a Menu Setting Page. Printed at the top of each page is
the model name and serial number to assist in tracking each page of a report to a specific printer. The printout of
the log contains the following information for each error in the log:
•
Page count when the error occurred (except for 900 service controller board software errors).
•
Code versions of all packages when error occurred.
•
Panel message when error occurred (except for 900 service controller board software errors).
•
Debug information and secondary error codes, depending on the error.
The Clear Log operation clears out the errors that print in this report. The errors listed in the Display Log
operation do not necessarily match in number nor in order with the errors from the printer log.
Note: This log can be printed from configuration menu, but the debug and secondary error codes are not
printed on this log.

Clear Log

This menu item deletes the event log. Once the event log is deleted, the only item remaining on the log is the
"Clear Log" event.
Touch Back to return to the EVENT LOG menu.

SCANNER TESTS

Scanner Calibration Reset

This option resets the scanner calibration values to factory default settings. This should be done after you
replace the flatbed scanner unit.
Note: Be sure the scanner glass and backing material are clean before performing this test.

ASIC Test

This test initiates a scan of the scanner ASIC memory. This is a pass/fail test.
X
Press Stop ( ) to clear the results message from the screen.

Feed Test

This test performs a continuous feed test of either the flatbed scanner or ADF without producing any printed
output or incrementing any of the scanner-related counters.
For an ADF test, select a paper size. The ADF then performs a duplex scan using the chosen paper size
settings. For a flatbed test, the scanner traverses the entire length of the flatbed.
X
Press Stop ( ) to end the test.
4036-310, -311
Previous
Go Back
3-23
Diagnostic aids
Next