Co-200/250 Coin Cell Battery Replacement; Decorative Plates - Schlage CO-Series Service Manual

CO-Series Service Manual

CO-200/250 COIN CELL BATTERY REPLACEMENT

Keypad Only locks contain the coin cell battery and holder on the PC Board Assembly, while the Removable Reader Type
locks have the coin cell battery within the back of the Reader Module.
Coin cell part number: 46929147
a
b
Keypad Only Type Locks

DECORATIVE PLATES

Decorative Plates are used to cover exposed holes when retrofitting from existing locks to CO-Series locks. Except for Exit
Trim Decorative Plate, all plates are 3.5" wide and 0.075" thick. The size of plate required will vary based on the size and
location of holes being covered. Retrofit information can be found at www.schlage.com/support.
Part
23631823
Number
Exit Trim
Decorative
Description Plate (1.5" H
x 3.25" W x
0.105" D
* Each plate is 0.075" thick, so if two Under Device Plate are required, the over door thickness will increase by more than ¹⁄₈".
Note: Please consider door thickness when specifying a new CO-Series lock or ordering a Door Thickness Kit. See page 41 for Door Thickness
Kits.
Example order: For CO 10.5" Decorative Plate with a 626 Finish, order would be: 23760259-626
40
Positive (+) side
facing as shown
b
a
23760267 23760283
1.7" 3.2"
6" Decorative
Decorative Decorative
Plate Plate
Mag Swipe Reader Type
Positive (+) side
facing as shown
23760317 23760325 23760309
6.6"
8" Decorative
Decorative
Plate
Plate
All other Reader Types
OR
Positive (+) side
facing as shown
Removable Reader Type Locks
23760291 23760259
8" Decorative
Decorative
Plate Plate
23760275
10.5" 12"
Decorative
Plate Plate