Configure Slot2 Module - D-Link DES-3225G Series User Manual

24-port NWay Ethernet Switch User's Guide
♦ Broadcast Storm Falling Action This setting will be activated when the Broadcast Storm Rising
Threshold and then the Broadcast Storm Falling Threshold (below) is met. This setting can be
configured to Do Nothing, Forwarding or Forwarding-Trap. See Broadcast Storm Falling Action in the
Configure Ports section of this manual for a more detailed explanation.
♦ Broadcast Storm Falling Threshold This setting defines the number of broadcast packets per
second on this port which will trigger the Broadcast Storm Falling Action (above). See Broadcast Storm
Falling Threshold in the Configure Ports section of this manual for a more detailed explanation.
Press APPLY to have the changes take effect.
STP Port State and Status reflect the current conditions of the port. They are read-only fields and cannot be
changed.

Configure Slot2 Module

This screen allows you to change the port state of an optional Gigabit Ethernet module in slot 2. This is useful
in the case when you would like to partition a port due to excessive collision, or for observation, device repair,
or security reasons. Great caution, however, must be observed when disabling a port, since all data passing
through the port will be discarded by the Switch.
The Configure Slot2 Module screen appears as follows:
♦ State Enables or disables this port.
Using the Console Interface
Figure 6-14. Slot2-Port Configuration screen
51