Table of Contents
Advertisement
RG-PA800IF
M8610/M8606-CM
M8610-CM is the primary management module of the RG-S8610; M8606-CM is the primary management module of
RG-S8606.M8610/M8606-CM performs such functions as system switching, system status control, route management,
user access control and management, and network maintenance. Inserted in slots M1 and M2 in the middle of the chassis,
the management module supports active/standby redundancy, hot backup and hot swapping.
In the system, there must be at least one M8610/M8606-CM for the system to work normally. However, you are
recommended to configure this module for both slots for higher reliability.
Module Appearance
Figure 1-9 Appearance of the M8610-CM
Figure 1-10 Appearance of the M8606-CM
External Interface
The M8610/M8606-CM module provides three external interfaces:
USB (Universal Serial Bus) interface: By connecting the USB interface, USB storage devices can keep logs, host
version, alarms and other diagnosis information, facilitating online upgrade of switch software and log saving.
To secure data and prevent damage to the device, it is recommended to use qualified USB disk. The USB interface
of the RG-S8600 is compatible with most USB controllers. Some models of USB disk may not be identified. You are
recommended to use Patriot and Start-net Digital USB disks.
Console port: As the serial communications port, it uses the RS-232 interface level and standard RJ-45 connector.
This port is used to connect the serial port of terminal computers running on the background for such tasks as
system debugging, configuration, maintenance, management, and host software loading.
10/100M MGMT port: As the 10/100BASE-T Ethernet port, it uses the RJ-45 connector. This port can be used to
connect the Ethernet port of the background computer for loading programs. When it is connected to the Ethernet
port of the background computer, the standard network cable can be used.
LED
Sign
Status
Primary
Alarm
10/100M MGMT
Port LED
It is the AC power module of the system. Instead of providing an input interface, it is
directly powered by the 220V AC through the interface on the back of the S8606 B
chassis.
Description
System LED
Primary/standby
management
module
LED
Fault alarm
Orange
LED
(full
duplex)
Green (Link/ACT)
Detailed information
OFF: The module is not powered on.
Red: The module is faulty.
Blinking green: The module is initializing. If it keeps blinking, the
module may be faulty.
Solid green: The module has finished initialization and can perform
switching well.
OFF: The module is a standby management module.
Green: The module is a primary management module.
OFF: No fault.
Red: System fault.
OFF: The module is working in the half duplex mode.
Orange: The module is working in the full duplex mode.
OFF: The port link is not up.
Green: The port link is up.
Blinking green: The port is sending and receiving data.
Advertisement
Table of Contents
