Installing Psu Modules Into The Psu Module Slots; Installing Ac Psu Modules - D-Link DXS-3610 Series Hardware Installation Manual

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Hardware Installation Guide

Installing PSU Modules into the PSU Module Slots

The Switch supports the installation of AC PSU (Power Supply Unit) modules and/or DC PSU modules into the PSU
module slots.
NOTE: The PSU modules support a specific airflow direction. This airflow direction must be the same as
the fan module(s) installed. The default airflow direction is front-to-back on all the installed PSU
modules and fan modules.

Installing AC PSU Modules

The Switch is shipped with two pre-installed AC PSU modules. This section can be referenced when one or more AC
PSU modules need to be replaced.
CAUTION: Make sure that the AC power cord is removed from the Switch and that the Switch is not
receiving any power. The power, fan, and other LED indicators must be off.
ATTENTION : Assurez-vous que le cordon d'alimentation CA est débranché du commutateur et que le
commutateur ne reçoit pas de courant. L'alimentation, le ventilateur et les autres voyants à LED
doivent être éteints.
To remove an existing AC PSU module, press the release clip to the side and gently pull the AC PSU module out of
the PSU module slot.
Insert the new AC PSU module into the PSU module slot until the release clip securely clicks into place.
Figure 3-8 Installing an AC PSU Module
12