Dispenser Control Panel - Electrolux Built-in 42" Service Manual

Dispenser Control Panel

The dispenser control panel contains the control module
and room ambient thermistor. The panel is available in
black or white. Stainless steel models come with black
trim. To remove the dispenser control panel on stainless
steel front models, insert a fl at-bladed screwdriver and
lift the frame outward to release the 15 retaining hooks
from the freezer door. Protect the freezer door with cloth
or tape to prevent marring the surface.
To remove the dispenser frame on trimmed models,
remove the door handle fi rst, then slide out the top panel.
The dispenser cover can then be removed by pulling it
away from the door front.
Note: Some force is required to remove the trim
frame.
Control Module
• The control module is located on the back of the
dispenser control panel.
• The control module is held in place by 8 Phillips-head
screws.
• The ambient thermistor is clipped to the bottom of the
module housing.
5995432258
Testing the Dispenser Control Pads
Run the HMI Self-Test 0 6 (see Service
Diagnostics). If any portion of the test fails, the control
module pads can be tested at the CN04 connector on the
terminal block (see Terminal Block Panel).
Disconnect the CN04 connector and read the resistance
between the wires to the control module. When each pad
is pressed, a reading of approximately 10K W should be
present between the pins as shown in the chart below.
As an example, when the REFRIGERATOR COLDER
pad is pressed, 10K W should be present
between the purple and white/blue wires (pin #8
and pin #14).
34