Table of Contents
Advertisement
Control Panel
(water dispenser)
H
H. Yellow indicator lamp
Lights up when the locking function has been
activated.
I. Button for carbonated water.
- Used for the choice of carbonated water.
- For the engagement and disengagement of the
locking function.
J. Button for ordinary water.
- Used for the choice of ordinary water.
- Switches the background lighting on and off.
Before use
Position and clean the cabinet as explained in the section
"Installation".
Check that the drain hose is located over the drip
bowl behind the refrigerator. Also ensure that the
drain hose is connected to the box. See the
illustration.
Before inserting the power plug into the
outlet and switching on the cabinet for
the first time, leave it standing upright
for about 4 hours. Otherwise the
compressor may sustain damage. This
time will allow the oil sufficient time to
return to the compressor.
Using the fridge
To start the fridge and set the
correct temperature
Switching on:
Switch on the fridge by pressing the power switch.
Setting the temperature
Press the buttons until the desired temperature
flashes in the temperature display (The temperature
can be set between +2°C and +8°C.)
"+" raises the temperature.
"-" lowers the temperature.
Once set, the temperature display shows "-" until the
temperature inside the fridge reaches +9°C or below.
Allow the cabinet to run for a period of 24 hours
whenever the temperature setting is changed. This
will allow the temperature to stabilise inside the
cabinet.
I
M
L
N
J
- Switches off the indicator lamp for water filter
replacement.
K. Yellow indicator lamp
Lights up when the water filter must be changed.
L. Water out-feed
Activated when a glass or something similar is
pressed upwards against the flap.
M. Flap
N. Lighting
4
K
5
ACTION
COOL
5
ACTION
COOL
Electrolux 8183821-00/1
GB
GB
Advertisement
Table of Contents
