Electrolux Built-in 42" Service Manual page 53

6. Carefully cut and remove the insulation on the suction
line and capillary tubing to expose the solder joints.
Note: Save the insulation to rewrap the refrigerant tubing
after brazing.
7. Recover the refrigerant. (See Evacuation and
Charging Procedures).
8. Disconnect the suction line and capillary of the
specific evaporator to be replaced. Note the position of
the tubing within the machine compartment. Pull the
evaporator tubing down from the cabinet and remove
the evaporator.
9. Install the new evaporator and carefully bend the
tubing to the correct position. Braze the suction line
and capillary tubing.
10. Replace the drier (part # WR86X93) and install a
process valve (part # WJ56X61) at the compressor.
11. Reinstall the remaining components within the cabinet
section while the braze joints are cooling.
12. Charge the system with the exact amount of
refrigerant (8.11 oz.) specifi ed on the rating plate
13. Check for refrigerant leaks at all joints.
14. Reinstall insulation around the tubing. Wrap with tape
to provide a good airtight seal.
15. Reinstall Styrofoam block and metal cover.
16. Check refrigerator for proper operation.
Service Diagnostics
53
5995432258