Door Closer Assembly - Electrolux Built-in 42" Service Manual

To install the door closer:
1. To make installation of the shock absorber easier,
secure the white nylon support to the cylinder body
with electrical tape.
2. Ensure the opening on the white nylon support faces
towards the inside of the cabinet.
NOTE: Tape in place when installing in the field, this will
prevent support from falling off before closer is in place.
3. Make sure the door closer assembly support is fully
seated in the bracket to ensure alignment of ball and
socket.
Side Magnet Replacement
1. Remove side case trim.
2. The hot gas loop will be visible between the front baker
strip and cabinet. Carefully move the hot gas loop
tubing out of the space between barker strip and cabi
net. The case magnet is behind the hot gas loop tubing.
3. With the hot gas loop out of the channel, the cabinet
magnet can be removed from the channel, using a flat
screw driver or putty knife to assist.
4. Rotate magnet and reinsert into breaker/cabinet
channel.
5. Reinsert hot gas loop tubing in breaker/cabinet channel
6. Tape may be necessary to hold hot gas loop tubing in
channel while trim is installed.
7. Re-install side trim.
25
Trim
Hot Gas loop
Magnet
Hot Gas loop
5995432258