Electrolux Built-in 42" Service Manual page 47

the freezer evaporator cover.
4. Remove the 2 Phillips-head screws that hold the rear
air duct cover in place, then pull it down.
5. Disconnect all the electrical connectors from the
ceiling.
6. Remove the rear air duct cover.
7. Remove the 2 Phillips-head screws from the suction
line drain pan and heater assembly. Disconnect the
associated wiring.
Note: The suction line drain pan heater has a resistance
value of 1.3K Ohm.
8. Carefully remove the styrofoam air duct.
Note: The styrofoam air duct is held in place by adhesive.
9. Remove the 2 Phillips-head screws that hold the freezer
plug cover in place, then remove the freezer plug cover.
Freezer Plug Cover
10. Disconnect the freezer evaporator wiring.
Note: When installing plug cover, place wiring
connectors inside the cover, then mount the plug
cover to the wall.
11. Remove the 2 Phillips-head screws that hold the
47
5995432258