Door Stop Assembly; Door Gasket And Inner Panel - Electrolux FPRH17D7KF All Refrigerator Professional Series Servicing

All Refrigerator-Pro
Door Stop Assembly Removal
The door stop is secured to with two screws the
underside of the door assembly.
To remove the door stop:
1. Remove door from unit.
2. Extract the two screws securing the door stop to the
bottom of the door assembly. (See Figure 5-5)
Door Gasket and Inner Panel Removal
The inner panel of the door assembly is secured with
screws that pass through the inner panel and fasten
into the door assembly. The door gasket has an inner
lip that is pressed between the inner panel and the door
assembly and is secured in position when the inner panel
screws are fastened to the door assembly. The inner
panel does not have to be completely removed to extract
the door gasket from the door assembly.
To remove the door gasket:
1. Lift the inside edge of the door gasket to access the
inner panel screws.
2. Loosen the inner panel screws until the door gasket
can be pulled out from under the inner panel.
(See Figure 5-6)
3. Continue loosening screws around door assembly
until door gasket is free.
4. To remove the inner panel, extract all screws from
the outside edge of the inner panel and remove from
unit.
5. The secondary gasket is secured with two retaining
clips that snap into the inner door panel. Pry out
the two retaining clips with a small putty knife, using
caution not to damage the inner door panel. The
secondary gasket is now free.
Section 5 Component Teardown
Figure 5-5. Door Stop Removal
Inner Panel
Clip
Secondary
Gasket
Clip
Screw
Figure 5-6. Inner Panel and Door Gasket Removal
Door Frame
Screws
Door Stop
Hinge Bearing
Outer
Door
Panel
Door
Gasket
5-3