Waeco PerfectCharge IU152A Installation And Operating Manual page 23

Using the IU0U automatic charger
10.1 Setting the IU0U automatic charger (fig. 8, page 7)
Charging voltage and time limit
Note
I
Ask your battery retailer for details on the charging voltage and time
limit required for your batteries.
Caution
a
Make sure that the device is never used if DIP switches 1 and 2 or
DIP switches 3 and 4 are both at the "ON" position. Only the switch
positions described in the following tables ensure the correct oper-
ation of the IU0U automatic charger.
Turn the main switch to "0".
Unscrew the four fastening screws (2) from the rear panel using the hex-
agon socket wrench provided.
Remove the rear panel (1).
Use the DIP switches (5) to set the required charging voltage and the du-
ration of the main charging phase (U0 phase, also see chapter "Charging
characteristics" on page 47):
Setting the charging voltage for IU152A, IU252A and IU452A:
Charging voltage
13.8 V
14.4 V
14.8 V
Setting the charging voltage for IU154A and IU254A:
Charging voltage
27.6 V
28.8 V
29.6 V
46
Switch 1 Switch 2
OFF OFF
ON OFF
OFF ON
Switch 1 Switch 2
OFF OFF
ON OFF
OFF ON
PerfectCharge
Area of application
Old starter batteries,
mains adapter operation
Wet and gel batteries
Fleece batteries
Area of application
Old starter batteries,
mains adapter operation
Wet and gel batteries
Fleece batteries