Connecting The Iu0U Automatic Charger - Waeco PerfectCharge IU152A Installation And Operating Manual

Connecting the IU0U automatic charger

9 Connecting the IU0U automatic
charger
Caution
a
The IU0U automatic charger may only be connected by a qualified
specialist.
The following information is intended for technicians who are famil-
iar with the guidelines and safety precautions to be applied.
Observe the following safety instructions for the electrical connections:
Caution, risk of short circuit
e
Always use sockets which are grounded and secured by resid-
ual current circuit breakers.
If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Fasten the cables securely.
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
Lay the cables so that they cannot be tripped over or damaged.
9.1 Connecting the IU0U automatic charger to a battery
(fig. 8, page 7)
Warning
d
Avoid coming into contact with the battery fluid.
Caution
e
Batteries with a cell short circuit may not be charged, as explosive
gases may form due to overheating of the battery.
42
PerfectCharge