Waeco PerfectCharge IU152A Installation And Operating Manual page 21

Connecting the IU0U automatic charger
Connecting the battery cables to the IU0U automatic charger
Note
I
The IU0U automatic charger's connections are suitable for cables
with cross-sections of 10 mm² to 25 mm².
Fit wire sleeves to the ends of the cables to ensure permanent contact.
Connect the positive battery cable to the respective slot:
– Supply battery: "BATT 1+", "BATT 2+", "BATT 3+"
– Starter battery: "START BATT +" (IU152A), "BATT 1+" (IU154A,
IU252A)
Connect the negative battery cable or earth cable to the respective slot:
– Supply battery: "BATT –"
The following instructions apply to all cables accordingly:
Fit cable sleeves on the ends of the cables (4).
Undo the safety bolt (3) slightly.
Insert the cable sleeves (4) in the slots provided.
Retighten the safety bolt (3).
Connecting batteries
Connect batteries according to the circuit diagram of your IU0U automatic
charger.
Closing the IU0U automatic charger
Refit the rear panel (1) and fasten it with the screws (2).
9.2 Connecting the 230 V power cable
Connect the 230 V connection cable (fig. 1 3, page 3) to the 230 V con-
nection (fig. 3 1, page 4) of the IU0U automatic charger.
Insert the plug of the 230 V connection cable (fig. 1 3, page 3) to an
earthed socket which is protected by a residual current circuit breaker.
44
PerfectCharge