Fastening The Iu0U Automatic Charger - Waeco PerfectCharge IU152A Installation And Operating Manual

Fastening the IU0U automatic charger

Rear view (fig. 3, page 4)
No. Description
1 230 V power supply connection
2 RC: connection for remote control (accessory)
3 TS: connection for temperature sensor (accessory)
4 Battery connection terminals
BATT 1+, BATT 2+, BATT 3+: positive terminal for supply batteries
BATT –: negative terminal
START BATT + (only IU152A), BATT 1+ (only IU154A, IU252A): posi-
tive terminal of the starter battery
7 Fastening the IU0U automatic charger
You can fasten the IU0U automatic charger using the four holders supplied.
When selecting the installation location, observe the following instructions:
You can mount the IU0U automatic charger either horizontally or vertical-
ly.
Do not operate the device
– In wet or damp environments
– In dusty environments
– In the vicinity of flammable materials
– In spaces where there is a danger of explosion
Select a well-ventilated location for the device.
A ventilation system must exist for installations in small, enclosed
spaces. The free space around the IU0U automatic charger must be at
least 5 cm.
Make sure that the ventilation slots on the front and back as well as under
the IU0U automatic charger are not covered.
Select a mounting surface which is flat and sufficiently firm.
Make sure you have adequate space for the mounting bracket behind the
device when choosing a mounting location.
Caution
a
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
40
PerfectCharge