Using The Iu0U Automatic Charger - Waeco PerfectCharge IU152A Installation And Operating Manual

PerfectCharge
9.3 Connecting the temperature sensor (accessory)
The temperature sensor measures the temperature at the battery or around
the battery and transfers the data to the IU0U automatic charger. The charg-
ing voltages specified in the chapter "Technical data" on page 52 refer to an
ambient temperature of 15 °C to 25 °C. If temperatures deviate, the charging
voltage is increased or reduced according to the diagram on page 49.
Turn the main switch to "0".
Lay the cable between the battery and the IU0U automatic charger.
Connect the temperature sensor to the TS socket on the back of the IU0U
automatic charger (fig. d 1, page 10).
Attach the sensor head directly to the battery (fig. d 2, page 10), e.g. us-
ing double-sided adhesive tape.
9.4 Connecting the remote control (accessory)
The remote control is for activating and deactivating sleep mode and for mon-
itoring the functions (see chapter "Functional check" on page 49) of the IU0U
automatic charger.
Lay the cable between the remote control and the IU0U automatic charg-
er.
Insert the plug of the remote control in the "RC" socket (fig. d 3, page 10)
of IU0U automatic charger.
10

Using the IU0U automatic charger

You can use the IU0U automatic charger to trickle charge empty batteries or
supply batteries.
Note
I
The chargers IU152A, IU252A and IU154A have a charger output
for the starter battery with an output voltage in the range between
13.2 V (26.4 V) and 13.8 V (27.6 V). The charger output for the
starter battery recharges the starter battery with a current of up to
1 A or maintains a high charge level.
Switch on the device with the main switch (fig. 2 1, page 3).
Using the IU0U automatic charger
45