Releasing The Carrier From The Base - Evenflo Embrace Owner's Manual

Rear-facing child restraint system
Hide thumbs Also See for Embrace:
Table of Contents

Advertisement

7
The level indicator must be completely green
If you have fully adjusted the convenience base and
the level indicator is still not level, use a tightly rolled
towel or small blanket
the base.
IMPORTANT: Infants may have difficulty breathing
when in a sitting position. Make sure they recline enough
for their head to lie back comfortably and safely. Failure
to properly recline the child restraint could increase the
child's risk of serious injury or death.
8
Move the handle to the "car" position by squeezing
both handle releases
it locks into place behind the carrier.
Ensure there is at least 38 mm (1.5 inches) of space
between any part of the carrier and the vehicle seat
that is closest to the child's head. You may need to
rotate the handle further down to the "stand"
position to provide enough room.
T
!
T
!
You may rotate the handle to the farthest
IP
IP
position behind the restraint for more
room in small vehicles.
.
beneath the front edge of
and rotating the handle until
24

Releasing the Carrier from the Base

1
Move the handle
to the "carry" position by
squeezing in on both handle releases
the handle until it locks into place above the carrier.
Squeeze the carrier release handle
the carrier.
and rotating
while lifting up
25

Advertisement

Table of Contents
loading

Table of Contents